Gilera Runner 125 VX 2001 ZAPM24200
Cdi Unit 4V 4 Stroke 12
van (aktiv: 1, cikklánc: ), 0.00
Leírás
Ez egy PIAGGIO gyári termék. Hozzávetőleges súly 240g.
How to program the immobiliser unit
- It is not possible to re-program an immobiliser unit to a new master key. Once it has been programmed it is irrevocably linked to that master key.
- It is not normally possible for an immobiliser to loose it's program and then need re-programming. If it was programmed and working but now it is saying that it is not programmed, First, check the HT lead and plug cap, It is possible that extreme electrical interference from a faulty HT circuit could upset the immobiliser. Plug cap must be at least 5000 ohms. Change the cap and lead if suspect. A resistor plug must be used on all Leader engines. Then try re-programming the immobiliser. If it will not re-program then it is faulty.
Programming a new immobiliser.
- Do not attempt to program a new immobiliser until you know that the fault is cured. Attach the new immobiliser, use the service key (not the brown master key) LED will give one long flash then go out and stay out. System is working correctly, Immobiliser is not programmed The engine should start but will not rev above 2000 rpm until the immobiliser is programmed.
- To program a new immobiliser
* Insert the brown master key and turn on for two seconds * Insert the service key and turn on for two seconds
* (extra service keys are included here)
- Insert the extra service key and turn on for two seconds * Insert the brown master key and turn on for two seconds
* The timing of the two seconds can be critical so use a watch to time it, you may need to do the sequence several times before it is accepted. * Changing from one key to the next should be done within ten seconds. *
* An extra service key is not just added,
you must go through re-programming all the keys as above.
You are not re-programming the master key, the master key is giving permission for the
service keys to be added.
* You do not need to start the engine just to check if the programming has been successful,
Just turn on the ignition and watch the LED.